Select Page

An engineering company specialising in the manufacture of containers and drums for the nuclear, aerospace and medical industries has been sentenced after a worker was fatally injured.

Preston Crown Court heard that on 21 May 2018, whilst working at the companies site, the employee was lying on his back, underneath the raised middle section of a Hugh Smith 1000 tonne capacity press, using a hand-held electric grinder to remove a weld from the base of a large metal piston. When the weld was removed, the internal ram fell through to the ground, crushing him resulting in instant death.

An investigation by the Health and Safety Executive (HSE) found the company failed to carry out a risk assessment and ensure a safe system of work on the Hugh Smith 1000 tonne capacity press. The 20-tonne middle section of the press was raised using fork lift trucks which exceeded their safe working load, in order to access the underside of the press.

Following a trial in front of a jury the company was found guilty of breaching Section 2(1) of the Health and Safety at Work etc. Act 1974. The Company was fined £500,000 and ordered to pays costs of £145,487

The director was acquitted of an associated charge under Section 37 of the Health and Safety at Work etc Act 1974.

Speaking after the hearing HSE principal inspector Steven Boyd said: “An unsafe system of work was adopted by the company whilst undertaking hazardous work and the ensuing sequence of events led to the untimely death of the employee. This tragic incident could have been avoided if the task had been adequately risk assessed and supervised to ensure safe procedures were followed”.

Source – HSE

HSCS Scotland Promoting a Healthier Workplace Through Safety

Pin It on Pinterest